Milling Machine GDZ-26 800W Water-Cooled Motor 62 Diameter Constant Mold Four Bearings 0.8kw Motor(380V)

MotorsThe working environment temperature of the is usually -10~40.Before installing the first electric to rotate the head by hand, you should feel flexibility and no blockage.P4 fully sealed angular joint ceramic bearings can extend the life of the .The longer the length, the greater the and the greater the power.Careful assembly makes the more precise.Accuracy is 0.01mm, coaxial cable is less than 0.0025mm1. Our ceramic ball bearing uses 4 ceramic ball bearings.2. Ceramic ball bearings are to high temperature and low heat, and are usually 3-5 degrees lower than steel ball bearings during use.3. Ceramic ball bearings have low friction, low noise and long service life.4. If the is used for aluminum or hardwood, ceramic ball bearings are better than steel ball bearings.When the is stored and transported, the bearing condition inside the high-speed grease will change, and the customer should run it at low speed for 30 minutes. Then increase slowly at a speed of 3000 rpm, running for 20 minutes each time. The and inverter should work together. The specifications and parameter settings of the inverter match the parameters.To connect the inverter main shaft, the three-phase inverter power cord should be welded to the 1 (U), 2 (V), 3 (W) pin, and the grounded pin 4. After turning on the power, observe whether the rotation axis always shows the direction. If it is inconsistent, turn it off immediately, and replace the two wires of the three-phase power supply connected to the inverter and the .Before using the every day, it must run at low speed for 15-20 minutes. Clamp the cutter on the , the chuck nut, chuck, and cutter must be clean enough. The shank inserted into the chuck must be larger than 15mm.The water-cooled must be used together with the water pump. Otherwise, the will quickly break.The AC motor must be used together with the inverter. The power of the inverter needs to be equal to or greater than the power of the . Before use, please set the inverter parameters suitable for the . Otherwise, the and inverter will break immediately.When using the , the noise is different from before, so please stop the immediately. You need to replace the bearing.The frequency power supply is connected to the rated voltage, and the frequency should be consistent with the technical parameters of the electric . The speed can be adjusted to change the frequency, and the voltage changes in proportion.Do not use the , apply compressed air to blow off the static coolant in the pipeline. To prevent rust, please the water hole. The should be oiled. Add anti-wave device and put it in a dry place.To replace the bearing, some professional and technical personnel should be replaced. With special tools, the bearings should be cleaned thoroughly without removing the stator coil.Reasonable designWater cooling design + exquisite workmanship + pure copper galvanized faucetFine workmanship and No noise, the noise is reduced to a very low level to protect the eardrums of workersStrong power and longer lifeFour bearings, high power and long service life sealing processThe head bearing adopts double dustproof design, which more effectively prevents foreign matter from entering.The frequency power supply is connected to the rated voltage, and the frequency should be consistent with the technical parameters of the electric . The speed can be adjusted to change the frequency, and the voltage changes in proportion.Do not use the , the should be oiled. Add anti-wave device and put it in a dry place.To replace the bearing, some professional and technical personnel should be replaced. With special tools, the bearings should be cleaned thoroughly without removing the stator coil.

• Motors
• Milling Machine GDZ-26 800W Water-cooled Motor 62 Diameter Constant Mold Four Bearings 0.8kw Motor